Keep ends of adjoining starter strips at least 1 4 inch apart to allow for expansion.
Putting up drip edge on trim siding attaching.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
Feed the shorter pieces alongside the window into the channel at the top of the window and slide them down into position.
Does the drip edge metal go under the tarpaper ice and water shield or underlayment on the eave.
T shape drip edge is an l shaped flashing in which the long leg folds back on itself before heading down 90 degrees to form the short leg.
Get the real story about drip edge placement.
If it doesn t pull the drip edge out slightly from under the shingles.
Turns out not all drip edge flashing perform the same.
Install these fragile starter strips with a 15 gauge.
Then slide it up and snap the butt into the locking edge of the piece below.
Secure the drip edge with roofing cement.
At the sides of the casings jab your brush into joints then smooth out the paint to seal them.
Nail in the center of the nailing slots.
Above the bottom of the wall sheathing as a guide.
Create a drip edge.
These strips installed at the bottom will make your first row of siding angle out to match the rest of the rows.
Find your most beat up pieces of siding and rip them down into 1 1 4 in.
Outward kick along the bottom.
L shape drip edge is a simple 90 degree bend with a flare out at the bottom of the short leg.
Without a drip edge water may end up beneath the shingles and may cause damage to various parts of the home.
This does two things it pushes the water a little further out away from the trim the flashing is protecting and it helps stiffen the bottom edge so it stay straight as the metal expands and contracts with temperature.
At the top of each casing you ll find a drip cap or metal flashing that tucks up under the siding.
Drip edges are metal sheets usually shaped like an l installed at the edge of the roof.
At casings and for the undersides of siding laps you may prefer to use a corner roller.
When installing the starter strips allow a 1 8 inch space for corner posts and j channels for expansion.
Paint a tight seal between metal and wood.
Push one end of longer pieces into the trim then bow the siding slightly and guide the other end into the trim.
Space the fasteners by about 12 inches.
To seal the edge of a siding panel where it has been cut and to secure it to the wall you can use under sill trim.
Some drip edge flashings actually help houses turn to mush.
As seen in m.
Use 1 inch galvanized roofing nails or 3 4 inch exterior screws.
The drip leg is at least 3 4 in.
Drip edge roof flashing types.
How to install a drip edge.
And i include a 1 4 in.
Also called drip edge flashing or d metal they serve a vital function by directing water away from the fascia and into the gutter.
Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and nailing or screwing it down.
