Putting Up Drip Edge On Trim Siding

Slide the corner tight to the fascia.

Putting up drip edge on trim siding.

Snap a line 1 in. Secure the drip edge with roofing cement. Cut along the corner of the facing edge. Installing drip edge on your roof.

When installing the starter strips allow a 1 8 inch space for corner posts and j channels for expansion. Create a drip edge. Find your most beat up pieces of siding and rip them down into 1 1 4 in. Just be sure they re positioned high up under the shingles.

Does the drip edge metal go under the tarpaper ice and water shield or underlayment on the eave. You may need to nail through the starter strip into the drip edge. Cut one piece of drip edge square on both edges to fit against the end of the roof. Bend the wide surface of the channel inward at this cut to make a drip edge tab and slide the tab under the sill channel.

With without rain gutters. Place a nail at one end then the other. At the bottom make a 1 in. If necessary secure the ends of the drip edge with short roofing nails.

Install these fragile starter strips with a 15 gauge. Cut the overlapping piece with the top edge to fit square against the end of the roof and the overhanging edge to fold around the corner. This is important to protect damage to your fascia soffits rafters. Outward kick along the bottom.

Nail in the center of the nailing slots. Tools supplies tin sn. Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge. As seen in m.

Get the real story about drip edge placement. These strips installed at the bottom will make your first row of siding angle out to match the rest of the rows. Slide the overlapping corner under the other overhanging piece of drip edge. Keep ends of adjoining starter strips at least 1 4 inch apart to allow for expansion.

And i include a 1 4 in. Apply a continuous bead of cement along the top of the drip edge then press down on the shingle. This does two things it pushes the water a little further out away from the trim the flashing is protecting and it helps stiffen the bottom edge so it stay straight as the metal expands and contracts with temperature.